Mauser Guns Collectors Forum
Pistols => C96 / C12 Broomhandle => Topic started by: bansil on June 05, 2018, 08:07:47 AM
-
Good morning,
I have been all over the internet (except at least 1 place :P ) looking for drawings/blue prints etc for a 9mm C96
I am looking to make one from billet using modern materials and heat treating etc
Any ideas where I can get accurate and usable drawings?
TIA
-
Oberndorf, Germany, circa 1900. (time machine option)
Their is someone in Russia who did some 3D renderings but I do not know how to get in touch with him.
You could always buy one, use it as a model and reverse engineer it.
Sorry, not much help I know.
Regards,
-
Thank you for the reply, I have been looking for one in shooting condition, most are too "nice" aka $$
we will see how it works out
-
Check out Gunbroker Item 773436898.