Pistols > Model HSC Pistol
Recoil spring Wolff
Freddyet:
Hi new to the forum - really happy to have found this platform - I have a interarm Mauser - a 34938 serial number , the gun has a few feeding issues - i shoot ball Ammo ( Remington 95 Grain ) feeds great in my walther ppks . I have ordered a new Wolff recoil spring . I replaced it this evening . The spring said for early models . 7.65 / 9 Kurtz . The spring is actually about a half an inch longer than the old spring . Is this going to be ok ? Just seemed strange to have a different length. Slide racks , and loads chamber fine . Shooting with my gun club Tomorrow . Want to make sure going to be safe . All seems fine . I will bring the original spring if I need to change . Thank you !!! I posted this under another topic Mauser police issue - my mistake - should be under new topic - sorry
Warbird:
I posted an answer in the "Police Issue HSc" thread but reply here on how it goes tomorrow.
Freddyet:
Thank you warbird ! I will report back . Sorry on the incorrect post . Want to say thank you for everything you contribute to this forum . Wonderful to have such an experienced expert to answer questions . Love my Mauser s !
jcorl:
So very true!!
Jim
Freddyet:
Just back from the range . Very big improvement in my pistol ! The new Wolff recoil spring made a big difference . I put 60 rounds through . I had one cartridge that did not chamber correctly . Before the spring replacement , I would have had 6 FTL ..... I think a little more polishing on the feed ramp , and will now replace magazine springs ( on the way from Wolff ) . l will continue to tune , so I will have a trusted carry HSC . THANK you again Warbird .
Navigation
[0] Message Index
[#] Next page
Go to full version