Pistols > Model HSC Pistol

HSC 32acp Disconnector

<< < (2/2)

Warbird:
That is correct.  Only the Grip Panel holds the Trigger Bar and Spring in place.

diceman3:
Again, thanks. Getting smarter every day, with your help.


Diceman3

diceman3:
Warbird, been awhile, but thanks for your explanation.
 This week, after firing the pistol, I improperly tried to field strip my Interarms HSC , and had the safety in the wrong position.
 When I tried to reassemble the pistol, with the hammer cocked, the trigger bar had come off.
How do I fix this?

vlim:
With the left grip removed, just press the triggerbar back in place, make sure it is seated well.


Keep some pressure on it, from the side, while installing the grip panel again.


It is quite normal for that bar to come loose, as it is held under pressure both front and rear.


Normal field strip after shooting only requires removal of the slide from the frame.


Proper method:
Check the pistol is empty.
Close the slide.
Cock the hammer.
Put safety on safe.
Press the release button and take off the slide.
Remove barrel and spring from the slide.


No further disassembly is required.

Navigation

[0] Message Index

[*] Previous page