Author Topic: Mauser WTP II frame markings  (Read 2351 times)

0 Members and 1 Guest are viewing this topic.

Investment Janitor

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Mauser WTP II frame markings
« on: December 09, 2021, 08:15:11 PM »
I'm sorry but I am new here not sure if the photo attached.

There is a marking on the bottom rear of the frame behind the magazine with the letter F, and another on the other side with the letter F and what looks like an E stamped over it, i have also seen some photos where numbers were present, including one with the number 5. Does anyone know why these markings are there?  Thanks! Best, Rob

1914mauser

  • Trusted Contributor
  • *****
  • Posts: 781
  • Karma: +28/-0
    • View Profile
Re: Mauser WTP II frame markings
« Reply #1 on: December 10, 2021, 10:03:13 AM »
Rob, These are most likely machinist or inspector markings that were done at the factory. Similar markings on HSCs were determined to indicate the machine or station that the frame was produced at. Regards, 
B. Mason
NAPCA member, NRA life member
aim small, mis small