Pistols > C96 / C12 Broomhandle

Cone Hammer Trigger

<< < (2/3) > >>

fasenda:
In general, as you can see on the picuture, the piece is sitting on two nodges (A and B), so you need to lift it first up a bit (C) and then in pull in direction D.
Normally the piece should slide out easily after a bit of pressure. If it does not slide out easily, then it usally means its corroded or there is some dirt there.
I suggest you try some rust remover or some other cleaning product.
If its stuck there due to dirt, you may use some wood piece to carefully hammer it upwards.

vietvet191:
Danke.  This is what I was looking for.

fasenda:
I'm curious, did you manage to get it out based on the steps provided?
Also, would you mind sharing some images of your weapon?
Ideally like one from each angle (top, back and from the side)
I'm particular curious about the serial number and how it looks overall.
If you are hesitant to share it in public, i would be grateful if you could share it with me via PM.
I would like these images for my collection.

vietvet191:
I apologize for taking so long to respond.  To answer your question, yes.  Your instructions worked perfectly.  The trigger came out with no problems at all.  I have attached a couple of pictures as you requested, but I'm afraid my skills at photography are not very good.

fasenda:
Thanks for the pictures, these are great!
I´m glad to hear that the trigger came off with no issue.
I´m still interested in the serial number, would you mind sharing it with me?
I assume that i probably won´t need it, since i´m assuming that the last two digits are 48, but it would be great to know for sure.

Navigation

[0] Message Index

[#] Next page

[*] Previous page