Pistols > C96 / C12 Broomhandle

Help! Slide stucks at loading position.

<< < (2/2)

reiver1:
I'd do a function check as that slide is impacting your bolt stop and should not..... cock the hammer and put one hand on the barrel, then grasp the bolt charging handle/wings and attempt to pull the bolt open.  Do not touch the lower frame.


The bolt should not move...it should be locked by the 2 lugs.  If it does move more than a minute fraction you have a non working locking system.  Mismatched parts or seriously worn lugs of the bolt or lug block.... or the internals are not functional as designed. This would create a blow back operation that is dangerous in that C 96.

Cultich:
I may have found the error.

I wanted to change the hammer spring and realised that something was missing or broken off.

I'll order the new one, put everything together and then test it and report back ;)

Cultich:
Problem solved ;)I replace the hammer spring an the broken part and it works fine !THX

Navigation

[0] Message Index

[*] Previous page