Rifles > General Mauser Rifle Questions
saving the Swede
(1/1)
capnkirk:
Hello all,
I recently purchased a Carl Gustafs M96 stamped 1900. It is almost entirely
intact with matching numbers on at least 12 separate parts. The stock disc
indicates a tight bore (6.51) in #1 condition, but of course that was many years ago and it has been messed with. The receiver has been drilled and tapped for modern sporter scope mounts :-\ and the bolt handle is turned down. Whoever did the bolt handle did a nice job.
Also, several parts (barrel bands and springs, trigger guard and floorplate, rear hand guard ring, sling swivel, and buttplate) are nickel plated. I don't think this is original, and if not I would like to return it to it's original look.
Original or not, the plating is deteriorated and I need to do something to
clean it up. Any advice will be greatly appreciated, thank you.
Trap4570:
Brownells sells a nickel remover. It's about the only safe method other than reverse plating which requires a plating setup and chemicals. All instructions are on their website.
Navigation
[0] Message Index
Go to full version