Pistols > Model HSC Pistol

HSc Takedown Problem

(1/6) > >>

f4wso:
Hi from Indiana,


I have what I believe is a 1943 Commercial HSc (#8437xx with only Eagle/N s) that a friend wanted me to clean up. I got the barrel latch loose under the trigger guard with kroll oil and it seems to move all the way down but the slide does not move forward at all so I can lift it out. Hammer is full back, safety on, mag out. Any tips on the best (wood hammer??) way to proceed?


Thanks in advance

jcorl:
Once upon a time, I had that problem.  There was old oil that had turned into varnish.  It just needs to move so slightly forward.  A hard tap with the heal of your hand should work.  A rubber mallet hangs in my shop for a gun that is rusted shut.  It leave no marks.  You said the mag was out!  You may want to take the grips off and Blaster it.  I like that product. 


JIm

f4wso:
Mags out. I'll try my rubber hammer

f4wso:
Thanks, tried the rubber hammer and some CLP Powder Blast to no avail. I will have to find and buy some Blaster next. Regards, Wib

jcorl:
Does the gun cycle?   

Jim

Navigation

[0] Message Index

[#] Next page