Messages

1

C96 / C12 Broomhandle / Re: Help! Slide stucks at loading position.

« on: December 20, 2023, 02:34:41 AM »

Problem solved ;)I replace the hammer spring an the broken part and it works fine !THX

2

C96 / C12 Broomhandle / Re: Help! Slide stucks at loading position.

« on: November 17, 2023, 03:53:35 PM »

I may have found the error.

I wanted to change the hammer spring and realised that something was missing or broken off.

I'll order the new one, put everything together and then test it and report back

3

C96 / C12 Broomhandle / Re: Help! Slide stucks at loading position.

« on: September 18, 2023, 02:40:55 AM »

I had loaded 5 rounds but stopped after the 5 because I didn't want to damage the gun.

The slide runs good as far as I can tell.

The return spring was changed for a new one.
I had heard from a German forum that almost all new springs are a little weak and PPU as ammunition would not be so good.

I should try Fiocchi

But at prices of 25 € for PPU and 75 € for Fiocci I had first decided for PPU

4

C96 / C12 Broomhandle / Help! Slide stucks at loading position.

« on: September 12, 2023, 10:24:38 AM »

Someone here who can help me?

I have purchased a C96 in the original caliber 7.63

Before I shot them the first time, i disassembly it and noticed that the firing pin was broken, so I replaced the firing pin, the firing pin spring and the slide spring.

Then I wanted to test it, but I have the problem that the bolt slide stuck in the loading position after every shot.
https://youtu.be/2bn-Iy9MqkU
What could be the reason for this?

Ammunition is 7.63 Mauser from PPU

Thank you