Mauser Guns Collectors Forum
General Category => General Discussion => Topic started by: soonerfan66 on October 15, 2020, 02:53:44 PM
-
Does anyone know about a reduced load for 7mm Mauser using IMR4895 , 160GR round nosed bullet . The chart shows 34.0 gr as minimum load but is it still safe to go lower some or would that cause pressure issues . Was doing test loads and from the higher test loads going down the group kept getting better so was wondering if I took it a bit lower would the group continue getting better . Had been using H4895 for years but ran out and trying to figure out my loads with the IMR4895 I was able to get .