Mauser Guns Collectors Forum
Pistols => C96 / C12 Broomhandle => Topic started by: pgbarrow on March 12, 2017, 03:44:14 PM
-
Hi everyone,
I have a C96 stock which needs some work. The bore for the stock bracket screw is about 1/2 inch while the screw is only 1/4. I was thinking some wood putty or a dowel rod, then drill out the right sized hole. The bracket is also slightly out of alignment so the screw will not properly line up, I would estimate I need to bend it inwards about 10 degrees. Any thoughts on how to repair this before I get our the blow torch? Sorry no pictures, everything I have tried to attach was too large.
Paul