Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - HSc742

Pages: [1]
1
Model HSC Pistol / Slide lock and feeding issues
« on: August 19, 2018, 03:55:14 PM »
I recently took possession of a family heirloom Kreigsmarine HSc (742869). It hadnít been fired in 25 yrs so I stripped it down, cleaned and lubed it. When I removed the grips, the additional parts like the trigger bar, disconnector, etc. came loose so I did my best to reassemble everything. Iím having issues with the slide being hard to pull back and not staying locked back. It will lock back with an empty mag inserted, but close when the mag is removed. It will not lock back with the mag out.

I took it to the range to test fire it the other day. I loaded a couple of rounds and inserted the mag with the slide closed, then attempted to manual cycle the slide and load the first round into battery. The round only went halfway into battery but with a gentle wiggle I was able to get it in and the slide closed. The pistol fired perfectly but the second round failed to enter battery on the cycle.I ordered a complete spring set from Wolff as one possible next step but havenít installed them. In general, should I go ahead and replace all of the springs on the set as a preventative measure or only change them out to solve a specific problem?

Any thoughts on what might be going on here? Any advice would be appreciated!  By the way, my pistol has clear, plastic grips, not the traditional wood ones. Theyíve been on there since at least the 1950ís. Any chance those were original or aftermarket? Theyíre milled to a precise form and fit for the pistol.

Best regards,HSc742

Pages: [1]