42
« on: August 28, 2018, 10:12:35 AM »
Rock Island Auction house has a HSc cutout going up on the auction block soon. Has anyone stared at that photo for an extended period of time? I have and I pose a question. If this is a correct, factory built, no serial number cutout, then what is that heat signature doing on the inside at the front of the trigger guard. Why is that heat signature shaped the way it is shaped? Why is there fading in the signature as it becomes further removed from the chamber? It strikes me as a non-typical location for a obvious metal discoloration to be on an example in the white. Perhaps this is just surface rust, but to me it looks different. Perhaps there was a hardening process going on at that location, that would explain it. I am just a HSc devotee with a lot to learn, and I must admit that I cannot figure this cutout coming from the factory. There is another piece of this gun that has me stumped also, but that is for a different time. (after someone spends $9,000 on it) Thank you to the forum for letting me post my interest.
Jim
Show Posts